Amer Networks SGD5 Uživatelská příručka

Gigabit Ethernet Switch User’s Guide Version 1.0 P/N: ATNSGD5082503 Rev.1 This User's Guide contains important information regardin

11 UNPACKING AND SETUP This chapter provides unpacking and setup information for the Switch. Unpacking Open the shipping carton of the Switch and car

12 IDENTIFYING EXTERNAL COMPONENTS This chapter describes the front panel, rear panel and LED indicators of the Switch Front Panel The figure below s

13 Power is supplied through an external AC power adapter. Check the technical specification section for information about the AC power input voltage

14 TECHNICAL SPECIFICATIONS General Standards: IEEE 802.3ab 1000BASE-T IEEE 802.3u 100BASE-TX IEEE 802.3 10BASE-T IEEE 802.3x Flow Control Protocol:

15 Physical and Environmental DC inputs: 7.5V 1.5A Power Consumption: 8.5 watts maximum Operating Temperature: 0 °C ~ 40°C Storage Temperature: -1

16 Amer.com Warranty Policy Limited Lifetime Warranty In the event of a defect in quality or workmanship, Amer.com will repair or replace any hardwa

17 Limits and Expectations There are no express warranties except as listed above. Network products by Amer.com shall not be liable for incidental or

1 Amer.com 7259 Bryan Dairy Road, Largo, FL 33777 USA © Amer.com Corp., 1997-2002 All rights reserved. No part of this publication may be reprodu

2 . Increase the separation between the equipment and receiver. . Connect the equipment into an outlet on a circuit different from that to which th

3 TABLE OF CONTENTS ABOUT THIS GUIDE ... 4 TERMS ...

4 ABOUT THIS GUIDE This user’s guide tells you how to install your 5-Port 1000BASE-T Gigabit Ethernet Switch, how to connect it to your Gigabit Ethe

5 INTRODUCTION This section describes the features of the 5-Port 1000BASE-T Gigabit Ethernet Switch, as well as providing some background information

6 packets at the MAC address level of the Ethernet protocol transmitting among connected Ethernet or fast Ethernet LAN segments. Switching is a cost-

7  Support Full duplex transfer mode for 1000Mbps  Full wire speed reception and transmission  Store-and-Forward switching method  Supports 8